The cyclon is a spiral-wound cell with thin lead foil electrodes. Because of this, we can use the this type of battery in any position. The oxygen recombination cycle eliminates the need to add water throughout the battery’s life and improves its safety of operation. This is one type of Lead acid rechargeable battery.
Due to the construction of VRLA Battery , it do not require ventilation and can be mounted in any orientation and do not require constant maintenance.
AGM VRLA Battery Construction As shown in Figure the AGM VRLA battery utilizes a separator of glass fibers which serves to both isolate the negative and positive plates and act as a blotter to absorb all the electrolyte within the cell. VRLA stands for valve-regulated lead-acid. A VRLA battery utilizes a one-way, pressure-relief valve system to achieve a “recombinant” technology. This means that the oxygen normally produced on the positive plate is absorbed by the negative plate.
This suppresses the production of hydrogen at the negative plate. Water (H 2O) is produced instea retaining the moisture within the battery. The S-Series is a premier, general duty sealed lead-acid battery using absorbent glass mat (AGM) technology to suspend electrolyte in a leak-proof, maintenance-free design.
This in increase of superficial area by a large extend.
The main feature of construction of lead acid battery is to accommodate a large volume of active materials i. Buy Top Products On eBay. The VRLA battery means the Valve Regulated Lead Acid Battery. This type of battery is sealed from outside. So there is no provision of topping up water or acid during its lifespan. It is a maintenance-free battery.
Mainly two varieties of VRLA battery are available in the market. These are Gel Cell and Absorbent Glass Mat Cell. This was a spirally wound construction similar to a capacitor. Gel-cells and absorbed glass-mat batteries are common in these roles, collectively known as VRLA ( valve-regulated lead–acid ) batteries.
In the charged state, the chemical energy of the battery is stored in the potential difference between the pure lead at the negative side and the PbO on the positive side, plus the aqueous sulphuric acid. It can be installed in various orientations. The reason for the construction techniques employed is driven by the fact that oxygen is a byproduct of charging process where water in the battery gets broken down into its hydrogen and oxygen components.
Valve regulated lead acid battery ( VRLA ) use a patented MFX alloy for the positive gri which exhibits excellent deep discharge performance. In addition it has a universally acclaimed maintenance free lead calcium alloy for the negative grid. The power stack cells so formed require very little maintenance and have longer life duration.
SLA and VRLA are different acronyms for the same battery , Sealed Lead Acid or Valve Regulated Lead Acid. This battery type has the following characteristics: Maintenance-free, leak-proof, position insensitive. Batteries of this kind have a safety vent to release gas in case of excessive internal pressure build up. Leoch university is committed to the five functions of talent development ,strategic promotion, knowledge management, resource and cultural shaping through the construction of a full and all-round training system.
The two batteries are classified as Valve Regulated Lead-Acid ( VRLA ) batteries. The oxygen produced on the positive plates of lead-acid batteries is absorbed by the negative plates. The sealed construction of the S-series battery allows trouble-free, safe operation in any position.
Rate) to 208Ah (Hr. Rate) Volt Block.
ليست هناك تعليقات:
إرسال تعليق
ملحوظة: يمكن لأعضاء المدونة فقط إرسال تعليق.